IPR512
Firmware Update


Current Version
[v2.65.000]
v2.65.000(released on February 26, 2015)
Firmware Download
Product Info

V2.40.000(released on September 30, 2013)
Firmware Download
Product Info

V2.21.000(released on April 24, 2012)
Firmware Download

What's New
  • The IPR512 now supports 1024 Supervised Paradox GPRS/IP Modules

V2.02.000(released on July 02, 2010)
Firmware Download
Product Info

What's New
  • New IPR512 restore events
  • Output Relay activation upon loss of communication with the automation software

V1.22.000(released on February 3, 2009)
Product Info

What's New
  • The IPR512 now supports the following additional communication protocols for event reporting to the monitoring station’s automation software: ADEMCO 685, SURGARD MLR2-DG, and RADIONICS 6500
  • You can now configure both CID and SIA codes when configuring the Receiver Event Settings.
  • You can now define the amount of time that the IPR512 GPRS/IP Monitoring Receiver will wait for an acknowledgement from the monitoring station’s automation software before sending an "Automation Communication Failure" message.

Improvements
  • Digits (0-9) can now be used when defining the login password set in the IPR512 Account Management System.

V1.11.000(released on October 31, 2008)

What's New
  • First official release to market

V1.00.000BETA(released on October 14, 2008)

What's New
  • This is a BETA version
  • You can now save changes to the configuration of the serial ports (COM1 and COM2) through the web Account Management interface. Previously changes were not saved

Improvements
  • The Link LED (green) on the LAN connector at the back of the unit no longer blinks

V0.72.000BETA(released on October 1, 2008)

What's New
  • This is a BETA version
  • This version must be used with hardware revision 850-7007-010. If required, refer to PC Board Exchange Instructions
  • New database. Databases from version v0.66 and earlier are not compatible with this version. You cannot restore backups from memory cards with databases from v0_66 and earlier
  • When reporting in CID, the 3 characters will be sent to the automation software and to the serial output. When reporting in SIA, the first 2 characters will be sent to the automation software and to the serial output

V0.48.000BETA(released on August 11, 2008)

نسخه چاپیارسال به دوستاندفعات بازدید: 36512345
تعداد آرا: 0

نظر شما:



Copyright © 2016 Powered by PoyaHost, All Rights Reserved.
امگا نوین تنها شرکت تخصصی سیستم های اعلام سرقت حرفه ای دزدگیر پارادوکس در ایران